F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
13. Connect the seat control switch electrical connector.
All seats
14. Restore the vehicle to operating condition.
1
Install the seat on the side with the affected safety belt retractor.
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS,
CAUTIONS, NOTES, AND INSTRUCTIONS IN THE SUPPLEMENTAL RESTRAINT SYSTEM
DEACTIVATION/REACTIVATION PROCEDURE. Refer to Air Bag(s) Arming and Disarming.
2
Reactivate the supplemental restraint system (SRS).
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, NOTES,
AND INSTRUCTIONS IN THE SEAT REMOVAL AND INSTALLATION PROCEDURE.
3
With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS). See: Air Bag(s) Arming and
Disarming/Service and Repair/Prove Out Procedure
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE
FROM THE VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE
VIOLATION OF VEHICLE SAFETY STANDARDS.
4
Check the active restraint system for correct operation.
15. Check the active restraints for correct operation.
Supercab
Safety Belt Bolt Bit
SPECIAL TOOL(S)
REMOVAL
1. Remove the shoulder safety belt guide.
1
Position the shoulder safety belt guide cover up.
2
Use the Seat Belt Bolt Bit to remove the bolt.
3
Remove the shoulder safety belt guide.
NOTE: Inspect the shoulder safety belt guide and cover for damage. If the shoulder safety belt guide or cover is damaged or cover does not
remain closed, install a new shoulder safety belt guide.
