F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
1. To install, reverse the removal procedure.
NOTE:
^
Make sure the safety belt webbing is not twisted prior to installation.
^
Make sure to tighten bolts to specification.
2. Check the restraint system for correct operation.
40/20/40 Seat, Driver and Passenger
REMOVAL
All vehicles
1. Remove the affected seat.
Driver safety belt buckle
2. Disconnect the safety belt warning switch electrical connector.
^
Remove the pin-type retainer from the safety belt warning switch electrical connector.
All vehicles
3. Remove the safety belt buckle.
1
Remove the safety belt buckle nut.
2
Remove the safety belt buckle.
NOTE: Driver side shown, passenger side similar.
Driver safety belt buckle
