F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
1. Install the safety belt retractor and pretensioner.
1
Position the safety belt retractor and pretensioner, aligning the tabs into the sheet metal.
2
Using the special tool, install the bolt.
NOTE: Make sure that after an Automatic Locking Retraction (ALR) retractor is installed that the retractor is not in the ALR mode of operation
when installed.
2. Remove the restraint system diagnostic tool from the safety belt retractor pretensioner electrical connector.
3. Connect the safety belt retractor pretensioner electrical connector.
CrewCab passenger side
4. Install the front passenger side safety belt anchor.
1
Position the front passenger side safety belt anchor.
