F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
7.
If shim installation is needed, install the shim as shown in Figures 2 and 3.
8.
Inspect U-bolts and replace if necessary.
NOTE
IF U-BOLT REPLACEMENT IS NECESSARY, REFER TO PART CATALOG FOR PROPER APPLICATION AND PART NUMBER
INFORMATION.
9.
After shim installation re-measure the vehicle ride height per Workshop Manual Section 204-00. If the ride height is now greater than 200 mm for
a single rear wheel vehicle, or 210 mm for a dual rear wheel vehicle replace the spring.
CAUTION
IF NECESSARY INSTALL NEW SUSPENSION FASTENERS. ALWAYS REPLACE FASTENERS WITH THE SAME PART NUMBER, OR
AN EQUIVALENT PART. DO NOT USE A REPLACEMENT FASTENER OF LESSER QUALITY OR DIFFERENT DESIGN. TORQUE
VALUES MUST BE USED AS SPECIFIED IN THE WORKSHOP MANUAL FOR CORRECT RETENTION OF COMPONENT.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
DEALER CODING
CONDITION
BASIC PART NO.
CODE
5560
63
Disclaimer
