F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
3. NOTE: The orientation of the relief hole must be down when installing the seal.
Align the extension housing seal in the extension housing.
4. Using the special tool, seat the extension housing seal.
5. Install the driveshaft.
6. Fill the transmission to the specified level with clean automatic transmission fluid.
7. Start the engine. Move the transmission range selector lever through all the gear ranges, checking for engagements.
8. With the vehicle in NEUTRAL, engine running and the transmission at normal operating temperature 66 - 77°C (150 - 170°F), check and adjust
the transmission fluid level, and check for any leaks. If fluid is needed, add fluid in increments of 0.24 liter (0.5 pint) until the correct level is
achieved (fluid should be in the cross-hatched area of the fluid level indicator).
Extension Housing Seal
Extension Housing Seal
