F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
2. Install the manual control lever shaft assembly.
1
Install the manual control lever shaft assembly.
2
Install and seat the manual lever shaft retaining pin below the case surface.
3
NOTE: The inner manual valve detent lever must be seated on the flats of the manual control lever shaft assembly, and the parking pawl
actuating rod must be through the guide plate.
NOTE: The manual control valve detent lever spring must be on the inner manual valve detent lever, and the detent lever pin must align with
the manual shift valve.
Install the parking pawl actuating rod and the inner manual valve detent lever.
4
NOTE: Use a crescent wrench on the manual control lever or the outer flats of the manual control lever shaft assembly when installing the
inner manual valve detent lever nut.
Install the inner manual valve detent lever nut.
3. Install filter and seal assembly, fluid pan and gasket.
4. Install the digital Transmission Range (TR) sensor.
1
Position the digital transmission range sensor.
2
Loosely install the bolts.
5. NOTE: Make sure that the manual control lever is in the neutral position.
Using the special tool, align the digital TR sensor. The tool is designed to fit snug.
