F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
3. CAUTION: After removal of the pinion nut, discard it. A new nut must be used for installation.
Remove the pinion nut using the special tool.
4. Remove the pinion flange, using the special tool.
^
Remove the rear axle drive pinion seal.
^
Remove the rear axle drive pinion shaft oil slinger.
5. Install the special tool and, with a soft-faced hammer, drive the pinion out of the front bearing cone and remove it through the rear of the housing.
6. NOTE: Remove the collapsible spacer and discard it.
Use the special tool to remove the pinion bearing.
