F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
All vehicles
8. Tighten the four bolts
9. Lower the vehicle.
Driveshaft-Rear, Two-Piece
Driveshaft-Rear, Two-Piece
Removal and Installation
1. Raise and support the vehicle.
2. Index-mark the driveshaft at the axle flange.
3. Disconnect the driveshaft from the axle flange.
1
Remove and discard the bolts.
2
Remove and discard the U-joint retainers.
^
Using mechanics wire, support the driveshaft.
