F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
4
Press on the spider to remove the remaining bearing cup.
5
Remove the driveshaft slip-yoke.
Final disassembly
6. Repeat Bearing cup removal in this procedure to remove the remaining bearing cups and the spider from the shaft.
7. Clean the yoke area at the end of the shaft.
Assembly
Bearing cup installation
1. NOTE: Install the Universal Joint Kits as complete assemblies only. Do not mix components from other Kits.
Install a new spider and bearing cup.
1
Start a new bearing cup in the shaft yoke.
^
Check the needle bearings for correct position.
2
Position the new spider in the shaft yoke.
3
Press the bearing cup to just below the snap rind groove.
2. NOTE: Use the yellow snap rings supplied in the kit to assemble the universal joint (U-joint). If difficulty is encountered with the yellow snap
rings, install the black snap rings.
Remove the shaft from the special tool, and install the new snap ring.
