F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
3. Remove and discard all four of the snap rings.
4. Clamp the special tool in a vise.
Bearing cup removal
5. NOTE: If necessary, use a pair of pliers to remove a bearing cup that fails to press out all the way.
Remove the bearing cups and the flange.
1
Position the flange in the special tool.
2
Press out a bearing cup.
3
Rotate the flange 180 degrees.
4
Press on the spider to remove the remaining bearing cup.
5
Remove the flange.
Final disassembly
6. Repeat Bearing cup removal in this procedure to remove the remaining bearing cups and the spider from the driveshaft.