F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
7. Clean the yoke area at the end of the driveshaft.
Assembly
Bearing cup installation
1. NOTE: Install the Universal Joint Kits as complete assemblies only. Do not mix components from other Kits.
Install a new spider and bearing cups.
1
Start a new bearing cup in the driveshaft yoke.
^
Check the needle bearings for correct positioning.
2
Position the new spider in the driveshaft yoke.
3
Position the driveshaft yoke in the special tool.
4
Press the bearing cup to just below the snap ring groove.
^
Repeat to install the new bearing cup on the opposite side of the driveshaft yoke.
Flange installation
2. Inspect the flange. Install a new flange, if necessary.
3. Install the new bearing cups and the flange.
1
Start a new bearing cup in the flange.
^
Check the needle bearings for correct positioning.
2
Position the flange on the spider.
3
Position the assembly in the special tool.
4
Press the bearing cup to just below the snap ring groove.
^
Repeat to install the new bearing cup on the opposite side of the flange.
