F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
Drive/Propeller Shaft: All Technical Service Bulletins
Drivetrain - Driveline Noise Under Light Load
TSB 07-13-7
07/09/07
DRIVELINE NOISE UNDER LIGHT LOAD-40-50 MPH
(64-80 KMIH) - 6.0L REGULAR CAB 4X2 WITH 137
INCH WHEELBASE
FORD:
2003-2007 F-250, F-350
ISSUE
Some 2003-2007 F-250/350 Super Duty vehicles equipped with a 6.0L engine, regular cab, and 137" wheel base may exhibit a driveline noise often
described as a scrapping noise and occurs in torque converter lockup between 40-50 MPH (64-80 Km/h) under light load at engine RPM 1200-1400.
ACTION
Replace the driveshaft following Workshop Manual, Section 205-01. This driveshaft has a dampener tuned for this specific noise.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
071307A
2003-2007 F-250/350 4X2
0.4 Hr.
6.0L: Replace The Rear
Driveshaft (Do Not Use
With 4602A)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
4602
42
Disclaimer
