F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
Transmission Position Switch/Sensor: Service and Repair
Automatic Transmission - TorqShift
Transmission Pressure Switch
Transmission Pressure Switch
Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the transmission fluid pan, gasket and filter
3. Disconnect the affected pressure switch electrical connector.
4. Remove the affected pressure switch.
^
Remove the retaining "W" clip.
^
Remove the affected pressure switch.
5. To install, reverse the removal procedure.
Digital Transmission Range (TR) Sensor
Digital Transmission Range (TR) Sensor
Removal
1. With the vehicle in NEUTRAL, position on a hoist.
