F 250 4WD Super Duty V8-5.4L (2009)
5. Remove the RH recliner-to-cushion frame bolts.
-
To install, tighten to 50 Nm (37 lb-ft).
6. Release the hook-and-loop strip on the cushion trim cover flap at the LH rear of the seat.
7. Release the LH J-clip.
8. Release the latch cable from the LH side.
1. Release the cable anchor.
2. Swivel the cable end and separate.
9. Remove the screw and recliner handle cover.
10. Remove the LH recliner-to-cushion frame bolts, slide the backrest assembly rearward and remove the backrest assembly.
-
To install, tighten to 50 Nm (37 lb-ft).
11. To install, reverse the removal procedure.
Seat Backrest - Front, Bucket Seat
Seat Backrest - Front, Bucket Seat
Removal and Installation
All seats
1. Remove the affected front seat. For additional information, refer to Seat - Front, Bucket Seat See: Service and Repair/Front Seats/Seat - Front,
Bucket Seat.