F 250 4WD Super Duty V8-5.4L (2009)
Remove and discard the 7 engine support insulator-to-crossmember nuts.
16. Using the Engine Support Bar, Support Hook and Engine Support Bracket, raise the engine assembly.
Automatic transmission equipped vehicles
17. Remove the 2 bolts and the flexplate inspection cover.
All vehicles
18. Remove 16 oil pan bolts and position the oil pan onto the crossmember.
19. Remove the 3 bolts and position the oil pump screen and pickup tube into the oil pan.
Automatic transmission equipped vehicles
20. Remove the oil pan and the oil pump screen and pick tube.
-
Inspect the oil pan gasket for damage.
-
Discard the oil pan gasket.
-
Discard the oil pump screen and pickup tube O-ring seal.
Manual transmission equipped vehicles
21. Position the oil pan onto the engine and install one bolt at the front and one bolt at the rear of the oil pan to hold it in position.
22. Using the Engine Support Bar, Support Hook and Engine Support Bracket, align the engine support insulator studs and lower the engine.
23. Remove the flywheel. For additional information, refer to Flywheel See: Service and Repair/Removal and Replacement/Flywheel.
