F 250 4WD Super Duty V8-5.4L (2009)
6. Using the Crankshaft Front Oil Seal Remover, remove and discard the crankshaft seal.
Installation
1. Lubricate the engine front cover and the new crankshaft seal inner lip with clean engine oil.
2. Using the Crankshaft Front Oil Seal Installer, the Crankshaft Vibration Damper Installer and the Front Cover Oil Seal Installer, install the new
crankshaft front seal into the engine front cover.
3. NOTE: If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with metal surface prep and silicone gasket
remover. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer. Failure to follow this procedure can cause future oil
leakage.
Apply silicone gasket and sealant to the Woodruff key slot in the crankshaft pulley.
4. Using the Crankshaft Vibration Damper Installer, install the crankshaft pulley.