F 250 4WD Super Duty V8-5.4L (2009)
12. Remove the starter solenoid cable eyelet nuts and ground cable studbolt and position the cables aside.
13. Remove and discard the 4 front stabilizer bar bracket nuts.
14. Disconnect the solenoid body electrical connector.
15. Disconnect the rear transmission fluid cooler tubes from the transmission case and remove them from the vehicle.
Installation
1. Install the rear transmission fluid cooler tubes into the vehicle and connect the transmission fluid cooler tubes to the transmission case.
-
Tighten to 40 Nm (30 lb-ft).
2. Connect the solenoid body electrical connector.
-
Tighten to 5 Nm (44 lb-in).
3. Install 4 new front stabilizer bar bracket nuts.
-
Tighten to 48 Nm (35 lb-ft).
