F 250 4WD Super Duty V8-5.4L SOHC VIN L (1999)
2. Install the caliper pistons.
1
Install the piston seals.
2
Install the dust boots.
3
CAUTION: Be careful not to damage or dislodge the piston seal.
Insert the caliper pistons.
4
Press the caliper pistons into the cylinder bore being careful not to cock the caliper pistons.
3. Install the rear disc brake caliper.
Removal and Installation
Removal
WARNING: Asbestos fiber dust may be present on brake and clutch assemblies and is hazardous to health if inhaled.
Brake and clutch assemblies should be cleaned using a vacuum cleaner recommended for use with asbestos fibers such as
brake/clutch/service vacuum. The bag must be labeled per OSHA instructions, sealed, and the trash hauler notified as to the bag's contents.
If a vacuum suitable for asbestos is not available, cleaning should be done wet. If dust generation is still possible, technicians should wear
government-approved toxic dust purifying respirators.
Occupational Safety and Health Act (OSHA) requires areas where asbestos dust generation is possible to be isolated and posted with
warning signs. Only technicians performing brake or clutch repair should be present in the area.
WARNING: Brake fluid contains polyglycolethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake
fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water
and induce vomiting. Get medical attention immediately.
CAUTION: Brake fluid is harmful to painted or plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Remove the caliper pin bolts.
