F 250 4WD Super Duty V8-5.4L SOHC VIN L (1999)
- Scroll highlighted bar to "TRANSMISSION," then press trigger button.
- Turn dial to the right and "ENABLED" will change to "DISABLED." Press trigger button.
- Press DONE (numeric 8 button) and the GEM module will be programmed to a manual transmission equipped vehicle.
Disconnect NGS from DLC.
Remove FSF Program Card from NGS.
Insert Diagnostic Card into NGS.
Connect NGS to DLC.
Retrieve and clear all Diagnostic Trouble Codes (DTC).
Retrieve DTC's again.
If there are no DTC's, proceed to Step 19. If ABS codes B2141 and/or B2477 are present, reconfigure the ABS module for correct tire/axle ratio as
follows:
- Disconnect NGS from DLC.
- Remove Diagnostic Card from NGS.
- Insert same Ford Service Function (FSF) Program card (software level of 4.0 or higher) into NGS.
- Connect NGS into the DLC.
- Turn ignition switch to Run position (engine off).
- Scroll highlighted bar to "SERVICE BAY FUNCTIONS," then press trigger button.
- Scroll highlighted bar to "ABS -ANTI LOCK BRAKE MODULE," then press trigger button.
- Scroll highlighted bar to "TIRE SIZE/AXLE RATIO CONFIGURE," then press trigger button.
^
If the NGS displays: "-COMMUNICATION LINK ESTABLISHED - YOU MUST MAKE SELECTION FOR THE FOLLOWING
FIELD: VEHICLE," press trigger button.
Scroll highlighted bar to "TIRE SIZE," then press trigger button.
- Turn dial to the right until correct tire size is displayed, then press trigger button.
- If tire size is not listed, rotate dial until "-- REVS/MILE" is displayed, then press trigger button. Use the following formula to calculate revolutions per
mile:
^
63360 divided by circumference of tire measured in inches. Add 2 zeros in front of the solution.
Enter this number into the NGS, then press trigger button.
- Scroll highlighted bar to "TONE RING SIZE." Verify 10.50 IN/27CM (00120) is displayed.
- Scroll highlighted bar to "OPTION," then press trigger button.
- Turn dial to the right until "N/A" is displayed. Press trigger button.
- Scroll highlighted bar to "VEHICLE," then press trigger button.
- Turn dial to the right until "F2501F350" is displayed. Press trigger button.
- Press DONE (numeric 8 button) and the ABS module will be reconfigured.
- Remove NGS from DLC.
