F 250 4WD Super Duty V8-5.4L SOHC VIN L (1999)
Installation
1. Position the wheel knuckle onto the axle housing.
2. Install the nut onto the lower ball joint. Do not tighten the nut at this time.
3. Install the insert and the castellated nut onto the upper ball joint. Do not tighten the nut at this time.
4. Tighten the lower ball joint retaining nut.
5. Install the cotter pin into the upper ball joint.
-
Tighten the upper ball joint castellated nut.
-
Install the cotter pin. If necessary, tighten the castellated nut until the cotter pin can be installed.
NOTE: Do not loosen the castellated nut to install the cotter pin.