F 250 4WD Super Duty V8-5.4L SOHC VIN L (1999)
7. WARNING: Replace with new bolts and retainers after the third removal.
Mark and remove the driveshaft to parking brake drum bolts.
8. Remove the center bearing support bolts.
9. Remove the front driveshaft.
10. Clean grease deposits, dirt and rust from the following:
^
The driveshaft yoke areas.
^
All driveshaft components.
^
Wipe the bearing and rubber insulator of the driveshaft center bearing. Do not immerse in solvent.
11. Inspect the following:
^
The universal joint slip yoke boot for rips or holes. Replace if necessary.
^
The driveshaft center bearing support for wear or rough action. If roughness or wear is evident, replace the driveshaft center bearing support.
^
The center bearing rubber insulator for evidence of hardening, cracking or deterioration. Replace if necessary.
Installation
1. WARNING: Replace with new bolts after the third removal.
NOTE: Prior to the third removal, clean the bolt threads and apply Loctite(R) 242 or equivalent. Install driveshaft to parking brake drum bolts.
Connect the front driveshaft to the transmission.
^
Hand tighten only; do not tighten at this time.
