F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
2. Remove the brake caliper flow bolt and discard the 2 copper washers.
^
To install, tighten bolt to 35 Nm (26 lb-ft).
3. CAUTION: Do not pry in the caliper sight hole to retract the pistons, as this can damage the pistons and boots.
Remove the 2 brake caliper bolts and the caliper.
^
To install (F-250/350 single rear wheel), tighten to 35 Nm (26 lb-ft).
^
To install (F-350 dual rear wheel), tighten to 76 Nm (56 lb-ft).
4. To install, reverse the removal procedure.
^
Bleed the brake caliper.
