F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
Removal
All vehicles
1. Remove the lower oil pan.
Partial Body Lift
2. Remove the oil level indicator. Remove the retaining nut for the oil level indicator tube.
Body On
3. Remove the oil level indicator.
All vehicles
4. Remove the bolt. Remove the oil level indicator tube and position it aside.
^
Remove and discard the O-ring seal.
5. Remove the bolt for the fuel tube retainer.
6. Remove the 9 bolts and the upper oil pan.
^
Remove and discard the press-in-place gasket. Clean and inspect the sealing surfaces.
Installation
All vehicles
1. Position a new press-in-place gasket, the upper oil pan and install the 9 bolts.
^
Tighten to 13 Nm (115 lb-inch).
2. Install the bolt for the fuel tube retainer.
^
Tighten to 31 Nm (23 lb-ft).
