F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
31. NOTE: Raise the supply tube up to clear the ECT sensor connector when repositioning the power steering pump.
NOTE: Make sure the power steering pressure tube retainer is on the retaining stud prior to tightening the bolts for the power steering pump.
Install the power steering pump and bolts.
^
Tighten to 25 Nm (18 lb-ft).
32. Install the retaining nut for the power steering hose and tube.
^
Tighten to 25 Nm (18 lb-ft).
33. If equipped, install the A/C drive belt.
