F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
28. NOTE: Install a new O-ring seal.
Install the EGR cooler coolant tube and bolt.
^
Tighten to 10 Nm (89 lb-inch).
29. NOTE: It may be necessary to position the tensioner to install the lower bolt. Install the lower bolt last.
Position back the FEAD assembly. Install the nuts and bolts.
^
Tighten to 47 Nm (35 lb-ft).
30. NOTE: Raise the supply tube up to clear the ECT sensor connector when repositioning the power steering pump.
NOTE: Make sure the power steering pressure tube retainer is on the retaining stud prior to tightening the bolts for the power steering pump.
Position back the power steering pump and install the bolts.
^
Tighten to 25 Nm (18 lb-ft).
