F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
Water Pump: Service and Repair
Coolant Pump
COOLANT PUMP
Removal and Installation
1. Drain the fuel and turbocharger cooling system.
2. Remove the LH fender splash shield.
3. Disconnect the radiator-to-coolant pump hose at the coolant pump.
4. Disconnect the coolant pump-to-fuel cooler hose at the coolant pump.
5. Remove the bolts and detach the coolant pump from the cooling module.
-
To install, tighten to 3 Nm (27 lb-in).
6. Disconnect the coolant pump electrical connector and remove the coolant pump.
7. To install, reverse the removal procedure.
-
Fill and bleed the fuel and turbocharger cooling system.
