F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
Vehicles with manual tilt wheel
13. Install the steering column manual tilt lever and screw.
-
Tighten to 6 Nm (53 lb-in).
All vehicles
14. Turn the ignition switch from OFF to ON.
15. Install the RCM fuse 32 (10A) to the SJB and install the cover.
16. WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any air bag module when the battery is
connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
Connect the battery ground cable.
17. Prove out the SRS as follows:
Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag warning indicator with the
air bag modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn off. If an air bag SRS
fault is present, the air bag warning indicator will either:
-
fail to light
-
remain lit continuously.
-
flash.
The air bag warning indicator may not illuminate until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON
position. This is the time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and an SRS fault
exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator will need to be repaired before diagnosis
can continue.
Clear all continuous memory DTCs from the RCM using a scan tool.
