F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
4. Open the valve on the bleeder tank.
5. Loosen the RH rear bleeder screw. Leave open until clear, bubble-free brake fluid flows, then tighten the RH rear bleeder screw and remove the
rubber hose and install the bleeder screw cap.
^
Tighten to 15 Nm (11 lb-ft).
6. Continue bleeding the system, going in order from the LH rear bleeder screw to the RH front disc brake caliper bleeder screw ending with the LH
front disc brake caliper bleeder screw.
7. Close the bleeder tank valve. Remove the tank hose from the adapter and remove the adapter from the brake fluid reservoir.