F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
EGR Temperature Sensor: Service and Repair
Exhaust Gas Recirculation Temperature (EGRT) Sensor - Inlet
EXHAUST GAS RECIRCULATION TEMPERATURE (EGRT) SENSOR - INLET
Removal and Installation
1. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls or the vehicle may be
damaged.
Turn the ignition switch to the OFF position.
2. Remove the RH inner fender splash shield.
3. Disconnect the glow plug module electrical connectors.
4. Disconnect the inlet exhaust gas recirculation temperature (EGRT) sensor electrical connector.
5. Remove the inlet EGRT sensor.
-
To install, tighten to 44 Nm (32 lb-ft).
6. To install, reverse the removal procedure.