F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
-
Apply clean engine oil to O-ring seals.
Install the quick connect coupling onto the tube until it is fully seated.
2. Connect the battery ground cable.
Disconnect - Type II
WARNING:
-
Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly
flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
-
Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result
in serious personal injury.
-
When working on or near the evaporative emission (EVAP) system, disconnect the battery ground cable from the battery. The EVAP
system contains fuel vapor and condensed fuel vapor, so an electrical spark may cause a fire or explosion. Failure to follow this
instruction may result in serious personal injury.
CAUTION:
-
When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector
retaining clip area before separating from the tube or damage to the tube or connector retaining clip can occur. Apply clean engine oil to
the end of the tube before inserting the tube into the connector.
-
Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is essential that absolute cleanliness is
observed when working with these components or component damage can occur. Always install blanking plugs to any open orifices or
tubes.
1. Release the locking tab on the coupling.
2. Separate the coupling from the fitting.
Connect - Type II
