F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
6. Disconnect the horn assembly electrical connector, the hood latch release cable position retainer and if equipped, disconnect the fog light electrical
connector position retainer.
7. Remove the bolt and the horns.
8. If equipped, disconnect the temperature sensor pushpin and position aside.
9. Remove the 2 air deflector pushpin retainers.
10. Disconnect the hood cable retainer. Remove the 2 power steering cooler bolts and position the power steering cooler aside.
11. NOTE:
-
Mark the front bolts to aid in installation.
-
Use care when removing the radiator core support to not damage the alignment pins.
Remove the 2 front bolts for the radiator core support.
-
To install, tighten to 63 Nm (46 lb-ft).
12. Remove the 4 top bolts for the radiator core support. Position the radiator core support forward to remove the CAC tube.
-
To install, tighten to 40 Nm (30 lb-ft).
13. Remove the CAC tube from the vehicle.
14. To install, reverse the removal procedure.
