F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
7. CAUTION: Do not disconnect the glow plug electrical connector before dislodging the seal from the valve cover or the wiring harness
may be damaged.
NOTE: Use a tool such as a body bone or trim fork to dislodge the seal. Do not use a screwdriver.
Using an appropriate tool, dislodge the glow plug wiring harness seal from the valve cover.
8. Disconnect the glow plug electrical connector by pulling on the glow plug wiring harness tee above the seal.
9. Install the special tool.
10. Remove the glow plug.
Installation
Both sides
1. Using the special tool, install the glow plug.
-
Tighten to 14 Nm (124 lb-in).
2. Connect the glow plug electrical connector and press the seal on the valve cover.
3. If necessary, attach the glow plug wiring harness retainer.
LH side
4. Connect the 3 wiring harness in-line electrical connectors at the LH frame rail and attach the electrical connectors to the bracket.
5. Install the LH fender splash shield.
RH side
6. If removed, install the RH fender splash shield.
7. If removed, install the air cleaner.
