F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
8. Remove the pushnuts and the glow plug module heat shield.
9. Disconnect the exhaust gas recirculation temperature (EGRT) sensor electrical connector.
10. Disconnect the glow plug module and fuel injection pump electrical connectors. Detach the electrical connector retainers.
11. Disconnect the pushpin retainer from the glow plug module bracket.
12. Remove the bolt for the engine wiring harness. Position aside the engine wiring harness.
13. Remove the bolts and the glow plug module bracket.
14. Disconnect the glow plug electrical connector and the wire retainer and position aside the engine wiring harness.
15. CAUTION: Do not disconnect the glow plug electrical connectors before dislodging the seals from the valve cover or the wiring harness
may be damaged.
NOTE:
