F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
37. Install the glow plug sleeve removal tool into the threaded sleeve and tighten. Use a wrench to thread the tool into the sleeve until the sleeve is
extracted.
38. Clean the glow plug bore with a stiff wire brush. Use filtered compressed air to remove any foreign material from the glow plug recess.
Installation
All vehicles
1. Verify the glow plug bore is completely clean and dry.
2. Apply Threadlock 262 sealant to the glow plug sleeve in 2 places.
3. Using the special tool, install the glow plug sleeve into the glow plug bore until it bottoms.
4. Clean the glow plug sleeve after installation with a nylon brush and solvent. Make sure the sealant is cleaned out before it hardens.
5. Install the glow plug(s).
