F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
Engine Control Module: Removal and Replacement
POWERTRAIN CONTROL MODULE (PCM)
Removal
1. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls or the vehicle may be
damaged.
Turn the ignition switch to the OFF position.
2. NOTE: Any PCM replacement will require that ALL customer keys are available to be reprogrammed at the time of installation. PCM
replacement DOES NOT require new keys.
Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation procedure.
3. Remove the air cleaner element.
4. Remove the transmission fluid level indicator.
5. Disconnect the PCM electrical connectors.
6. Detach the wiring harness retainer.
7. Remove the nuts and the PCM.
Installation
1. Position the PCM and install the nuts
-
Tighten to 7 Nm (62 lb-in).
2. Attach the wiring harness retainer.