F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
outboard passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems
increases the risk of serious personal injury or death in a crash.
Driver safety belt buckle
1. WARNING: Turn the ignition OFF and wait one minute to deplete the backup power supply. Failure to follow this instruction may
result in serious personal injury or death in the event of an accidental deployment.
Turn the ignition OFF and wait one minute to deplete the backup power supply.
2. Disconnect the driver safety belt buckle switch electrical connector and separate it from the mounting bracket.
LH center safety belt buckle
3. Using an appropriate tool, push in the pin hole while pulling the safety belt tongue out of the safety belt buckle.
-
After installation, when inserting the safety belt tongue into the safety belt buckle, make sure the safety belt buckle and safety belt retractor
webbing are not incorrectly twisted.
All safety belt buckles
4. Remove the bolt and the appropriate safety belt buckle(s).
-
To install, tighten to 55 Nm (41 lb-ft).
5. NOTE:
-
When installing a new safety belt buckle assembly, make sure it is installed on the correct side. This is due to the safety belt buckles and
tongues being different sizes from the LH to the RH side.
-
Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
