F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
portion, a new safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be
restored to its original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt
assemblies and attaching hardware may increase the risk of serious personal injury or death in a crash.
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard
passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the
risk of serious personal injury or death in a crash.
1. Fold the rear seat backrest down.
2. Remove the C-pillar trim panel.
3. Remove the safety belt retractor.
-
Remove the safety belt retractor bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
-
Pull the safety belt retractor away from the sheet metal, disengaging the anti-rotation tab.
-
Remove the safety belt retractor.
4. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
5. Check the active restraint system for correct operation.
Safety Belt Retractor - Rear, Outboard, SuperCab
SAFETY BELT RETRACTOR - REAR, OUTBOARD, SUPERCAB
