F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
Installation
1. Install the selector lever cable bracket onto the transmission.
^
Tighten to 48 Nm (35 ft. lbs.).
2. Move the manual lever into the (D) position by moving it all the way forward, and then move it 3 detents rearward.
3. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is
snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the sector lever
cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull
back on the selector lever cable end to make sure that the end is correctly installed.
NOTE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the selector
lever cable bracket.
Install the selector lever cable into the bracket and install a new retaining clip.
