F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
5. Separate the lower shift lever and gearshift lever blocks from the shift housing.
Installation
1. Install the lower gearshift lever and gearshift lever blocks into the shift housing.
^
Install the gearshift lever blocks with the notches facing downward.
2. CAUTION: Do not use a silicone sealing compound.
NOTE: Do not wait longer than 10 minutes to tighten the bolts due to the rapid cure time of the sealant.
Install the shift housing.
^
Apply Gasket Maker to the sealing surfaces.
^
Tighten to 23 Nm (17 ft. lbs.).
3. Install the lower shift lever boot.
4. Apply Threadlock(R) and Sealer to the gearshift lever bolts, and install the upper gearshift lever.
^
Tighten to 35 Nm (26 ft. lbs.).
5. Install the shift lever boot.
