F 250 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
Hydraulic Brake Booster: Service and Repair
Removal and Installation
Brake Booster - Hydro-Boost
BRAKE BOOSTER - HYDRO-BOOST
Removal and Installation
WARNING: The power brake booster should not be carried by the accumulator, nor should it ever be dropped on the accumulator. Check
the snap ring on the accumulator for proper seating before the power brake booster is used. The accumulator contains high pressure
nitrogen gas and can be dangerous if mishandled.
WARNING: If the accumulator is to be disposed of, it must not be exposed to excessive heat.
Before discarding the accumulator, drill a 1.6-mm (1/16-inch) diameter hole in the end of the accumulator can to relieve the gas pressure. Always
wear safety glasses when performing this operation.
All vehicles
1. With the engine off, depress the brake pedal several times to discharge the accumulator.
2. Disconnect the battery ground cable. On vehicles equipped with dual batteries.
3. Remove the left side battery.
4. Remove the air cleaner housing.
5. Remove the brake pressure switch electrical connector.
F-Series vehicles
6. Disconnect the power steering pressure hoses.
