F 250 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
Oil Temperature Sensor For ECM: Service and Repair
Oil Suction Gun
SPECIAL TOOL(S)
REMOVAL
1. Turn the ignition switch to the OFF position.
CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
2. Remove the plug. Using special tool 303-D104 (D94T-9000-A) draw the oil from the high-pressure oil pump reservoir.
3. Disconnect the Engine Oil Temperature (EOT) sensor electrical connector. Remove the EOT sensor.
INSTALLATION
1. Follow the removal procedure in reverse order.
^
Fill the high pressure oil pump reservoir with clean engine oil before installing the plug.
