F 250 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
Wastegate Solenoid: Adjustments
CAUTION: Failure to follow this procedure exactly can cause the turbocharger to overboost resulting in severe damage to the turbocharger or the
engine.
NOTE: The adjustment procedure can be performed on-vehicle. This procedure is performed with the turbocharger removed from the vehicle for clarity
purposes only.
1. Disconnect the pressure line from the wastegate control solenoid.
2. Install the adjustment rod end onto the wastegate control solenoid, if removed.
3. Press the wastegate crank toward the wastegate control solenoid.
4. Using the pressure pump apply 34.5 kPa (5 psi) of pressure to the actuator diaphragm.
