F 250 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
4. Remove the shipping clip from the safety belt retractor.
5. Push in on the B-pillar trim panel, securing the remaining retaining clips.
6. Install the front driver side safety belt anchor.
1
Position the safety belt anchor.
2
Using the special tool 501-010 (T77L-2100-A), install the bolt.
NOTE: Make sure the safety belt webbing is not twisted prior to installation.
7. Install the rear assist handle, rear door scuff plate and front door scuff plate.
8. Check the restraints system for correct operation.
Passenger Side
Safety Belt Bolt Bit
SPECIAL TOOL(S)
REMOVAL
NOTE: Safety belt buckles, height adjusters, center adjust tongues and belts and retractors can be replaced separately. However, if a safety belt
assembly was in use during a collision, the belt and retractor must be replaced as well as the center adjust tongue and belt and buckle assembly or the
center adjust tongue and the cable and buckle assembly. When replacing safety belts and buckles, height adjusters, safety cables and buckles, center
adjust tongues and belt and retractors, use only the replacement parts specified in the Ford Master Parts Catalogs for the make and model of the vehicle
being serviced. Safety belt assemblies must not be interchanged between vehicle models.
