F 250 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
INSTALLATION
All vehicles
CAUTION: Use care not to induce contamination in the form of dirt or foreign material when installing either of the sensors.
1. If removed, install the OSS.
1
Lubricate the O-ring and install the OSS.
2
Install the bolt.
2. Position the heated oxygen sensor (HO2S) connector back in place.
3. If removed, install the TSS.
1
Lubricate the O-ring and install the TSS.
2
Install the bolt.
4. Connect the electrical connector to the affected sensor.
5. Install the crossmember to the transmission mount, using one nut to hold the crossmember in place. Raise the transmission and align the
crossmember bolt holes.
