F 250 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
15. CAUTION: When installed correctly, the flat side of the clutch pedal position switch must face the tab protruding from the clutch master cylinder
, and the switch wiring connector must be in the 12 o'clock position. Incorrect installation will damage the clutch pedal position switch and cause
insufficient clutch pedal travel.
Install the clutch pedal position switch on the clutch master cylinder push rod, and secure it with the switch cover.
16. Install the new the push rod bushing.
17. WARNING: The clutch pedal is under spring tension.
Connect the clutch master cylinder push rod to the clutch pedal.
18. Raise and support the vehicle.
19. Correctly route the hydraulic tube and slave cylinder (7A564) to the transmission.
20. Install the slave cylinder.
^
Compress and twist the slave cylinder to lock it onto the transmission.
21. Connect the clutch hydraulic tube to the floor pan clip.
22. Lower the vehicle.
