F 250 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
3. Disconnect the driveshaft from the axle flange.
1
Remove and discard the bolts.
2
Remove and discard the U-joint retainers.
^
Using mechanics wire, support the driveshaft.
4. NOTE: Index-mark the driveshaft to transfer case or transmission flange.
For four-wheel drive vehicles, or vehicles equipped with a manual transmission, disconnect the driveshaft from the transfer case or transmission.
^
Remove and discard the bolts.
^
Using mechanics wire, support the driveshaft.
5. For vehicles equipped with an automatic transmission, index-mark the output shaft to slip yoke.
6. Remove the center bearing support bolts.
7. Remove the driveshaft assembly.
^
For vehicles equipped with an automatic transmission, lower the driveshaft and slide the driveshaft rearward off of the transmission output
shaft.
^
Plug the extension housing to prevent fluid loss.