F 350 2WD Pickup V8-351 5.8L VIN H 4-bbl HP (1985)
Axle Bearing: Service and Repair
Dana/Spicer Integral Housing Type
DISASSEMBLY AND ASSEMBLY
Bearings, Cups and Seals
Vehicles equipped with dual wheel rear axles have the wheel and tire assembly attached to the drum with integral two-piece swiveling lug nuts.
WARNING: DO NOT ATTEMPT TO USE PAST MODEL LUG NUTS (CONE SHAPED, ONE-Piece) TO REPLACE THE INTEGRAL
TWO-PIECE SWIVELING LUG NUTS. IF SO USED, PAST MODEL LUG NUTS CAN COME LOOSE IN VEHICLE OPERATION. DO
ATTEMPT TO USE PAST MODEL WHEELS, WHICH HAVE CONE SHAPED LUG NUT SEATS, ON THIS VEHICLE. DO NOT
ATTEMPT TO USE THE NEW DESIGN WHEELS AND LUG NUTS ON PAST MODEL WHEEL HUBS. ATTEMPTED USE OF
INTERMIXED WHEELS CAN LEAD TO DAMAGE TO THE WHEEL MOUNTING SYSTEM AND COULD RESULT IN WHEELS
COMING LOOSE IN OPERATION.
Rear Wheel Hub-Dana Full-Floating Axle F-250, F-35O
1. Set the parking brake and loosen the axle shaft attaching bolts.
2. Raise the rear wheels off the floor and place safety stands under the rear axle housing so that the axle is parallel with the floor. Release parking
brake and back off the rear brake adjustment, If necessary.
3. Remove the axle shaft attaching bolts and lock washers and discard them.
4. Remove the axle shaft and discard the gasket.