F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
Brake Bleeding: Service and Repair
With ABS
Anti-Lock Brake Adapter Controls
NOTE: Perform this procedure only if the hydraulic control unit (HCU) has been replaced. Follow conventional bleed procedures if the HCU is
not being replaced.
1. Perform Pressure Bleeding procedure.
2. Connect Anti-Lock Brake Adapter T9OP-50-ALA (bleeder box) and Anti-Lock Brake Adapter T93T-50-ALA jumper cable).
3. Press down on the brake pedal and depress the VALVES button on the bleeder box (brake pedal will fall).
4. Release the VALVES button and release the brake pedal.
5. Repeat Steps 3 and 4 once more.
6. Depress the MOTOR START button and let the pump motor run for one minute.
7. Perform Pressure Bleeding procedure a second time.