F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
RABS Valve: Service and Repair
REMOVAL
1. Disconnect the inlet and outlet brake lines from the Rear Wheel Antilock Brakes (RABS) valve. Cap the lines.
2. Disconnect the wiring harness to the RABS valve.
3. Remove the three nuts retaining the RABS valve to the frame rail and remove the RABS valve.
INSTALLATION
1. Position the RABS valve on the frame rail. Install the three nuts and tighten to 17-23 Nm (12-17 ft. lbs.).
2. Connect the RABS valve wiring harness connector.
3. Connect the brake lines to the RABS valve and tighten as follows:
a. 1/2-20 threaded fittings use 14-23 Nm (11-17 ft. lbs.)
b. 7/16-24 threaded fittings use 14-20 Nm (11-15 ft. lbs.)
4. Bleed the brake system. It is not necessary to energize the valve electrically to bleed the rear wheel cylinders.
CAUTION: Do not overtighten the fittings.
