F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
Parking Brake Control
8. Disconnect the front parking brake cable and conduit from the cable connector.
9. Remove the parking brake control and front cable from the vehicle.
10. Disconnect the barrel end of the front parking brake cable and conduit from the parking brake control.
11. Disconnect the cable conduit from the parking brake control by inserting a 1/2-inch 12-point box end wrench over the conduit snap fitting to
compress the retaining fingers. Back out the snap fitting.
INSTALLATION
1. Route the cable end fitting over the cable shoe. Snap the conduit fitting into the parking brake control. Insert the barrel end into the hole in the
track.
Parking Brake Control
2. Position the parking brake control to the steering column support bracket and install the three retaining nuts. Tighten to 17-23 Nm (13-17 ft. lbs.).
3. Raise and support the vehicle.
